- Three levels of transmitter amplification.
- Automatic or manual selection of transmitter operation modes
- Phase detection mode
- Rceiver operation with four transmitters at the same time to locate interruptions or distinguish wires
- ALED bright torch
- Screens backlight for work in dark
- Transmission battery status and settings of the transmitter to the receiver
- Operation in wide range of rated voltage, up to 500V RMS
- Measurement of voltage at the object to 500 Vrms
- Five modes of wire tracer operation - voltage, current, current-voltage, power and clamp
- Software upgrade via USB
- Additional accessories enable precise localization - such as
--
The Sonel LKN-720 Wire Tracer Transmitter sends electromagnetic signals that are appropriately modulated. This enables distinguishing these signals from other signals that may be present in a tested circuit or its close environment. The signal is also characteristic for respective transmission modes to enable the receiver to remotely interpret the signal. Transmission modes are switched automatically depending on the connected circuit, which is traced.
Starting the transmission will activate LED. The green color of the signaling LED indicates the correct transmission of tracing signals, while the red color of LED red indicates the incorrect choice of the operating mode for the type of the circuit connected with the transmitter.
Locating power points and switches in buildings
The pulse generated by an LKN-720 transmitter with a specific frequency allows us to locate and identify sockets and switches in energized and de-energized circuits.
Locating power points and switches in buildings
The pulse generated by an LKN-720 transmitter with a specific frequency allows us to locate and identify sockets and switches in energized and de-energized circuits.
Additional areas of use
- Detection of wires and cables (live or not)
- detection of cables in ceilings, walls, and floors,
- detection of breaks in cables,
- tracing cables in building installation,
- locating power points and switches in buildings,
- locating short circuits between leads,
- tracing shielded cables,
- tracing cables in metal ducts.
- Identification of fuses on the distribution board.
- Tracing underground cables.
- Tracing conductive water and heating pipelines.
- Non-contact detection of live cables.